SNIS244 September   2025 ISOTMP35R

ADVANCE INFORMATION  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1  Absolute Maximum Ratings
    2. 5.2  ESD Ratings
    3. 5.3  Recommended Operating Conditions
    4. 5.4  Thermal Information
    5. 5.5  Insulation Specification
    6. 5.6  Power Ratings
    7. 5.7  Safety-Related Certifications
    8. 5.8  Safety Limiting Values
    9. 5.9  Electrical Characteristics
    10. 5.10 Typical Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Features Description
      1. 6.3.1 Integrated Isolation Barrier and Thermal Response
      2. 6.3.2 Analog Output
        1. 6.3.2.1 Output Accuracy
        2. 6.3.2.2 Drive Capability
        3. 6.3.2.3 Common Mode Transient Immunity (CMTI)
      3. 6.3.3 Thermal Response
    4. 6.4 Device Functional Modes
  8. 7 Application and Implementation
    1. 7.1 Application Information
      1. 7.1.1 External Buffer
      2. 7.1.2 ADC Interface Considerations
      3. 7.1.3 Electromagnetic Noise Mitigation
        1. 7.1.3.1 Filtering Techniques
        2. 7.1.3.2 General Design Guidelines
        3. 7.1.3.3 PCB Layout Practices
      4. 7.1.4 Insulation Lifetime
    2. 7.2 Power Supply Recommendations
      1. 7.2.1 PSRR Considerations
    3. 7.3 Layout
      1. 7.3.1 Layout Guidelines
      2. 7.3.2 Layout Example
  9. 8 Device and Documentation Support
    1. 8.1 Documentation Support
      1. 8.1.1 Related Documentation
    2. 8.2 Receiving Notification of Documentation Updates
    3. 8.3 Support Resources
    4. 8.4 Trademarks
    5. 8.5 Electrostatic Discharge Caution
    6. 8.6 Glossary
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

Package Options

Mechanical Data (Package|Pins)
  • DFP|12
Thermal pad, mechanical data (Package|Pins)
Orderable Information

7.1.3.2 General Design Guidelines

While filter design depends on system-level noise sources, the following practices are recommended:

  • Place a 0.1µF bypass capacitor as close as possible to the ISOTMP35R VDD pin. This capacitor is required for optimal operation and should always be present, even when additional filters are used.

  • Use C0G/NP0 capacitors for signal-path filtering, and limit SMT package size to 0603 or smaller to minimize parasitic effects.

  • When selecting ferrite beads for high-frequency filtering, ensure DCR < 1Ω to avoid voltage drops that could introduce additional noise on VDD.

  • Use low-ESR capacitors, which provide a low-impedance path to ground and improve high-frequency noise suppression.