The OPA830, while operating on a single 3V or 5V supply, works well with high-frequency active filter designs. Again, the key additional requirement is to establish the dc operating point of the signal near the supply midpoint for highest dynamic range. Figure 8-10 shows an example design of a 1MHz low-pass Butterworth filter using the Sallen-Key topology.

Figure 8-10 Single-Supply, High-Frequency Active Filter

Both the input signal and the gain setting resistor are ac-coupled using 0.1μF blocking capacitors (actually giving bandpass response with the low-frequency pole set to 32kHz for the component values shown). As discussed for Figure 8-1, this configuration allows the midpoint bias formed by the two 1.87kΩ resistors to appear at both the input and output pins. The midband signal gain is set to +4 (12dB) in this case. The capacitor to ground on the noninverting input is intentionally set larger to dominate input parasitic terms. At a gain of +4, the OPA830 on a single supply shows 30MHz small- and large-signal bandwidth. The resistor values are slightly adjusted to account for this limited bandwidth in the amplifier stage. Tests of this circuit show a precise 1MHz, –3dB point with a maximally flat pass band (greater than the 32kHz ac-coupling corner), and a maximum stop-band attenuation of 36dB at the amplifier –3dB bandwidth of 30MHz.