SPRUJ10E May   2022  – May 2025

1.   1
2.   Description
3.   Features
4.   4
5. 1Preface: Read This First
   1. 2.1 Sitara MCU+ Academy
   2. 2.2 If You Need Assistance
   3. 2.3 Important Usage Notes
6. 2Kit Overview
   1. 3.1 Introduction
   2. 3.2 Kit Contents
   3. 3.3 Specification
      1. 3.3.1 Key Features
      2. 3.3.2 Component Identification
      3. 3.3.3 Functional Block Diagram
   4. 3.4 Device Information
   5. 3.5 BoosterPacks
   6. 3.6 Compliance
   7. 3.7 Security
7. 3Board Setup
   1. 4.1 Power Requirements
      1. 4.1.1 Power Input Using USB Type-C Connector
      2. 4.1.2 Power Status LEDs
      3. 4.1.3 Power Tree
   2. 4.2 Push Buttons
   3. 4.3 Boot Mode Selection
8. 4Hardware Description
   1. 5.1  Functional Block Diagram
   2. 5.2  GPIO Mapping
   3. 5.3  Reset
   4. 5.4  Clock
   5. 5.5  Memory Interface
      1. 5.5.1 QSPI
      2. 5.5.2 Board ID EEPROM
   6. 5.6  Ethernet Interface
      1. 5.6.1 Ethernet PHY #1 - CPSW RGMII/ICSSM
      2. 5.6.2 Ethernet PHY #2: CPSW RGMII/ICSSM
      3. 5.6.3 LED Indication in RJ45 Connector
   7. 5.7  I2C
   8. 5.8  Industrial Application LEDs
   9. 5.9  SPI
   10. 5.10 UART
   11. 5.11 MCAN
   12. 5.12 FSI
   13. 5.13 JTAG
   14. 5.14 Test Automation Header
   15. 5.15 LIN
   16. 5.16 MMC
   17. 5.17 ADC and DAC
   18. 5.18 EQEP and SDFM
   19. 5.19 EPWM
   20. 5.20 BoosterPack Headers
   21. 5.21 Pinmux Mapping
9. 5EVM Revision Design Changes
   1. 6.1 Rev A Design Changes
10. 6Hardware Design Files
11. 7References
    1. 8.1 Reference Documents
    2. 8.2 Other TI Components Used in This Design
12.   Trademarks
13. 8Revision History