SBAU249A October   2015  – July 2025 ADS9110

 

  1.   1
  2.   2
  3.   Trademarks
  4. 1Evaluation Module Overview
    1. 1.1 ADS9110EVM-PDK Features
    2. 1.2 ADS9110EVM Features
  5. 2Analog Interface
    1. 2.1 Connectors for Differential Signal Source
    2. 2.2 ADC Differential Input Signal Driver
      1. 2.2.1 Input Signal Path
      2. 2.2.2 Input Common-Mode Jumper Configuration
      3. 2.2.3 R1 Setting vs Source Impedance
    3. 2.3 Onboard ADC Reference
  6. 3Digital Interfaces
    1. 3.1 multiSPI® for ADC Digital IO
  7. 4Power Supplies
  8. 5 ADS9110EVM-PDK Initial Setup
    1. 5.1 Default Jumper Settings
    2. 5.2 EVM Graphical User Interface (GUI) Software Installation
  9. 6 ADS9110EVM-PDK Operation
    1. 6.1 EVM GUI Global Settings for ADC Control
    2. 6.2 Register Map Configuration Tool
    3. 6.3 Time Domain Display Tool
    4. 6.4 Spectral Analysis Tool
    5. 6.5 Histogram Tool
    6. 6.6 Linearity Analysis Tool
  10. 7Hardware Design Files
    1. 7.1 Schematics
    2. 7.2 PCB Layout
    3. 7.3 Bill of Materials
  11. 8Revision History

7.2 PCB Layout

Figure 7-3 through Figure 7-6 illustrate the EVM PCB layout.

ADS9110EVM PCB Layer 1: Top LayerFigure 7-3 ADS9110EVM PCB Layer 1: Top Layer
ADS9110EVM PCB Layer 2: GND PlaneFigure 7-4 ADS9110EVM PCB Layer 2: GND Plane
ADS9110EVM PCB Layer 3: Power PlanesFigure 7-5 ADS9110EVM PCB Layer 3: Power Planes
ADS9110EVM PCB Layer 4: Bottom LayerFigure 7-6 ADS9110EVM PCB Layer 4: Bottom Layer