SNAU318 June   2025 LMX1205

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specifications
    4. 1.4 Device Information
  6. 2Hardware
    1. 2.1 Additional Images
    2. 2.2 Jumper Information
    3. 2.3 Multiplier Lock Detect Jumper
    4. 2.4 Setup
      1. 2.4.1 Evaluation Setup Requirement
      2. 2.4.2 Connection Diagram
    5. 2.5 Power Requirements
    6. 2.6 Reference Clock
    7. 2.7 Output Connections
    8. 2.8 Test Points
  7. 3Software
    1. 3.1 Software Description
    2. 3.2 Software Installation
    3. 3.3 USB2ANY Interface
  8. 4Implementation Results
    1. 4.1 Buffer Mode
    2. 4.2 Multiplier and Divider Modes
    3. 4.3 Logic Clock
    4. 4.4 Programmable Delay
  9. 5Hardware Design Files
    1. 5.1 Schematics
    2. 5.2 PCB Layouts
    3. 5.3 Bill of Materials (BOM)
  10. 6Additional Information
    1. 6.1 Trademarks

2.8 Test Points

Table 2-2 SPI Signal Test Points
TEST POINT NAME SIGNAL
CSB1 CSB
SDO1 SDO
SDI1 SDI
SCK1 SCK
SEL1 SEL0
SEL2 SEL1
Table 2-3 Supply and Ground Test Points
TEST POINT NAME SIGNAL
TP1, TP2, TP3, TP4 GND
DC IN1 Voltage from external power supply
TP1_LDO1 Voltage out of the onboard LDO1
(DC IN1 = TP1_LDO1 in bypass mode)
TP1_LDO2 Voltage out of the onboard LDO2
(DC IN1 = TP1_LDO2 in bypass mode)
TP1_LDO3 Voltage out of the onboard LDO3
(DC IN1 = TP1_LDO3 in bypass mode)