Inicio Administración de potencia Controladores e interruptores de lado alto Interruptores inteligentes de lado alto de eFuse
Inicio
Administración de potencia
Controladores e interruptores de lado alto
Interruptores inteligentes de lado alto de eFuse
NUEVO

TPS4816-Q1

ACTIVO

Controlador automotriz de 100 V, corriente quiescente baja, de lado alto, con I2t, protección contra

Haga su pedido ahora
Hoja de datos

TPS4816-Q1

ACTIVO
Hoja de datos Haga su pedido ahora

Detalles del producto

FET External Number of channels 1 Rating Automotive Operating voltage (max) (V) 100 Operating voltage (min) (V) 3.5 Control interface GPIO Features Current monitoring, Current sense/monitor, Fault Diagnostic, High-side RSNS, I2T, MOSFET Gate Driver, Over Voltage Protection, Overcurrent protection with adjustable delay, Overtemperature protection, Precharge FET driver, Reverse polarity protection, Second Gate Drive, Short circuit protection, Under voltage lock out Current sense accuracy +/-2% at 30-mV VSNS Operating temperature range (°C) -40 to 125
FET External Number of channels 1 Rating Automotive Operating voltage (max) (V) 100 Operating voltage (min) (V) 3.5 Control interface GPIO Features Current monitoring, Current sense/monitor, Fault Diagnostic, High-side RSNS, I2T, MOSFET Gate Driver, Over Voltage Protection, Overcurrent protection with adjustable delay, Overtemperature protection, Precharge FET driver, Reverse polarity protection, Second Gate Drive, Short circuit protection, Under voltage lock out Current sense accuracy +/-2% at 30-mV VSNS Operating temperature range (°C) -40 to 125
VQFN (RGE) 23 16 mm² 4 x 4

  • AEC-Q100 automotive qualified for grade 1 temperature
  • 3.5V to 95V input range (100V absolute maximum)
  • Reverse input and output protection down to –60V
  • Integrated 12V charge pump
  • Low 1µA shutdown current (EN/UVLO = Low)
  • Dual gate drive: GATE = 0.5A src/2A sink, G = 100µA src/0.39A sink
  • Integrated pre-charge switch driver (INP_G) to drive capacitive loads
  • Accurate I2t overcurrent protection (IOC) with adjustable circuit breaker timer (I2t)
  • Accurate (±5%) and fast (5µs) short-circuit protection
  • Accurate analog bi-directional current monitor output (IMON, I_DIR): ±2% at 30mV VSNS
  • NTC based overtemperature sensing (TMP) and monitoring output (ITMPO)
  • Fault indication (FLT) during short circuit fault, I2t, charge pump UVLO, OV, overtemperature
  • TPS48160-Q1 (I2t enabled), TPS48161-Q1 (I2t disabled)
  • Accurate (±2%) and adjustable undervoltage lockout (UVLO) and overvoltage protection (OV)

  • AEC-Q100 automotive qualified for grade 1 temperature
  • 3.5V to 95V input range (100V absolute maximum)
  • Reverse input and output protection down to –60V
  • Integrated 12V charge pump
  • Low 1µA shutdown current (EN/UVLO = Low)
  • Dual gate drive: GATE = 0.5A src/2A sink, G = 100µA src/0.39A sink
  • Integrated pre-charge switch driver (INP_G) to drive capacitive loads
  • Accurate I2t overcurrent protection (IOC) with adjustable circuit breaker timer (I2t)
  • Accurate (±5%) and fast (5µs) short-circuit protection
  • Accurate analog bi-directional current monitor output (IMON, I_DIR): ±2% at 30mV VSNS
  • NTC based overtemperature sensing (TMP) and monitoring output (ITMPO)
  • Fault indication (FLT) during short circuit fault, I2t, charge pump UVLO, OV, overtemperature
  • TPS48160-Q1 (I2t enabled), TPS48161-Q1 (I2t disabled)
  • Accurate (±2%) and adjustable undervoltage lockout (UVLO) and overvoltage protection (OV)

TPS4816-Q1 is a family of low IQ smart high side drivers with protection and diagnostics. With wide operating voltage range of 3.5V to 95V, (100V absolute-maximum rating) the device is suitable for 12V, 24V, and 48V automotive system designs.

The device has a strong 0.5A peak source and 2A peak sink GATE driver that enables power switching using parallel FETs in high current system designs. Use INP as the gate driver control input. MOSFET slew rate control (ON and OFF) is possible by placing external R-C components.

It also integrates a pre-charge driver (G) with control input (INP_G). This features enables designs that must drive large capacitive loads. In shutdown mode, the controller draws a total shutdown current of 1µA at 48V supply input.

The device has accurate bi-directional current sensing (±2%) output (IMON, I_DIR) with adjustable I2t based overcurrent and short circuit protection (±5%) using an external RSNS resistor and FLT indication. Auto-retry and latch-off fault behavior can be configured. The device also has NTC based temperature sensing (TMP) and monitoring output (ITMPO) output for overtemperature detection of external FETs.

TPS4816-Q1 is available in a 23-pin VQFN package.

TPS4816-Q1 is a family of low IQ smart high side drivers with protection and diagnostics. With wide operating voltage range of 3.5V to 95V, (100V absolute-maximum rating) the device is suitable for 12V, 24V, and 48V automotive system designs.

The device has a strong 0.5A peak source and 2A peak sink GATE driver that enables power switching using parallel FETs in high current system designs. Use INP as the gate driver control input. MOSFET slew rate control (ON and OFF) is possible by placing external R-C components.

It also integrates a pre-charge driver (G) with control input (INP_G). This features enables designs that must drive large capacitive loads. In shutdown mode, the controller draws a total shutdown current of 1µA at 48V supply input.

The device has accurate bi-directional current sensing (±2%) output (IMON, I_DIR) with adjustable I2t based overcurrent and short circuit protection (±5%) using an external RSNS resistor and FLT indication. Auto-retry and latch-off fault behavior can be configured. The device also has NTC based temperature sensing (TMP) and monitoring output (ITMPO) output for overtemperature detection of external FETs.

TPS4816-Q1 is available in a 23-pin VQFN package.
filter Buscar otro/a Interruptores inteligentes de lado alto de eFuse
Descargar Ver vídeo con transcripción Video

Documentación técnica

star =Principal documentación para este producto seleccionada por TI
No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.
Ver todo 1
Tipo Título Fecha
* Data sheet TPS4816-Q1 100V Low IQ Automotive High-Side Switch Controller With Bi-directional IMON, I2t, OV, and Diagnostics datasheet PDF | HTML 27 may 2025

Diseño y desarrollo

Para conocer los términos adicionales o los recursos necesarios, haga clic en cualquier título de abajo para ver la página de detalles cuando esté disponible.

Herramienta de cálculo

TPS4816-Q1-CALC — TPS4816-Q1 design calculator

The design calculator allows customer to size the external peripheral components while designing with the TPS4816-Q1 controller.
Productos y hardware compatibles

Productos y hardware compatibles

Productos
Interruptores inteligentes de lado alto de eFuse
TPS4816-Q1 — Controlador automotriz de 100 V, corriente quiescente baja, de lado alto, con I2t, protección contra
Descargar
Encapsulado Pines Símbolos CAD, huellas y modelos 3D
VQFN (RGE) 23 Ultra Librarian
Se aplican los Términos y condiciones estándar de TI para los elementos de evaluación.

Pedidos y calidad

Información incluida:
  • RoHS
  • REACH
  • Marcado del dispositivo
  • Acabado de plomo/material de la bola
  • Clasificación de nivel de sensibilidad a la humedad (MSL) / reflujo máximo
  • Estimaciones de tiempo medio entre fallas (MTBF)/fallas en el tiempo (FIT)
  • Contenido del material
  • Resumen de calificaciones
  • Monitoreo continuo de confiabilidad
Información incluida:
  • Lugar de fabricación
  • Lugar de ensamblaje

Los productos recomendados pueden tener parámetros, módulos de evaluación o diseños de referencia relacionados con este producto de TI.

Soporte y capacitación

Foros de TI E2E™ con asistencia técnica de los ingenieros de TI

Ver todos los temas del foro en inglés

El contenido lo proporcionan “tal como está” TI y los colaboradores de la comunidad y no constituye especificaciones de TI. Consulte los términos de uso.

Si tiene preguntas sobre la calidad, el paquete o el pedido de productos de TI, consulte el soporte de TI. ​​​​​​​​​​​​​​

Videos