SLUSG35A August 2026 – November 2026 TPS12S24F-Q1
ADVANCE INFORMATION
The device includes a programmable fuse protection for each channel, that is based on a defined time-current curve and is commonly referred to as I2T protection in melting fuse datasheets. The intent is to match the switch turnoff behavior of a melting fuse. The NOM_CUR_CHx bits and I2T_TRIP_CHx bits set the time-current curve and immediate shutdown protection (ISC) to create the full I2T protection for the device. The I2T protection of the device consists of three regions:
The I2T protection of the device consists of three regions:
The operational region for the fuse-based shutdown is shown in the Figure 7-10. Exemplary values for the current values that bound the operational region is included.
The nominal current region (1) defines the region where the device can supply current indefinitely without turning off. This is roughly equivalent to the fuse current rating of a melting fuse. This region is set by the NOM_CUR_CHx bits and if the output current is less than the NOM_CUR_CHx setting then the device can supply current indefinitely as previously stated and it does not start the I2T accumulation. If the output current is greater than or equal to the NOM_CUR_CHx setting then the device enters the I2T accumulation loop and starts to accumulate until the I2T_TRIP_CHx threshold is met. If the output current falls back below the NOM_CUR_CHx before the I2T_TRIP_CHx value is reached then the device starts the I2T de-accumulation.
Above the nominal current region, is the fuse shutdown region (2) which is set by the I2T_TRIP_CHx bits. This region defines the curvature of time-current curve and the region where the I2T accumulation of the device is active and where I2T_MOD_CHx is set to 1. Based on the output current level and the NOM_CUR_CHx setting the device trips at different time intervals based on the I2T_TRIP_CHx value that is set. Depending on the DCR_CHx bit in the I2T_CONFIG_CHx register, the time-current curve of the device is defined by the equations in the following sections.