These 8-bit latches feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. They are particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers.
The eight latches of the ’BCT373 devices are transparent D-type latches. While the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When the latch enable is taken low, the Q outputs are latched at the logic levels that were set up at the D inputs.
A buffered output-enable (OE)\ input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines without interface or pullup components.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
OE\ does not affect the internal operations of the latches. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
| Typ | Titel | Datum | ||
|---|---|---|---|---|
| * | Data sheet | SN54BCT373, SN74BCT373 datasheet (Rev. D) | 11 Mär 2003 | |
| * | SMD | SN54BCT373 SMD 5962-90746 | 21 Jun 2016 | |
| Application note | Power-Up Behavior of Clocked Devices (Rev. B) | PDF | HTML | 15 Dez 2022 | |
| Application note | Implications of Slow or Floating CMOS Inputs (Rev. E) | 26 Jul 2021 | ||
| Selection guide | Logic Guide (Rev. AB) | 12 Jun 2017 | ||
| Application note | Understanding and Interpreting Standard-Logic Data Sheets (Rev. C) | 02 Dez 2015 | ||
| User guide | LOGIC Pocket Data Book (Rev. B) | 16 Jan 2007 | ||
| Application note | Semiconductor Packing Material Electrostatic Discharge (ESD) Protection | 08 Jul 2004 | ||
| Application note | TI IBIS File Creation, Validation, and Distribution Processes | 29 Aug 2002 | ||
| Application note | Bus-Interface Devices With Output-Damping Resistors Or Reduced-Drive Outputs (Rev. A) | 01 Aug 1997 | ||
| Application note | Designing With Logic (Rev. C) | 01 Jun 1997 | ||
| Application note | Input and Output Characteristics of Digital Integrated Circuits | 01 Okt 1996 | ||
| Application note | Live Insertion | 01 Okt 1996 |
Weitere Bedingungen oder erforderliche Ressourcen enthält gegebenenfalls die Detailseite, die Sie durch Klicken auf einen der unten stehenden Titel erreichen.
| Gehäuse | Pins | Herunterladen |
|---|---|---|
| CDIP (J) | 20 | Optionen anzeigen |
| LCCC (FK) | 20 | Optionen anzeigen |
Inhalte werden ohne Gewähr von TI und der Community bereitgestellt. Sie stellen keine Spezifikationen von TI dar. Siehe Nutzungsbedingungen.
Bei Fragen zu den Themen Qualität, Gehäuse oder Bestellung von TI-Produkten siehe TI-Support.