홈 전력 관리 고압측 스위치 및 컨트롤러 스마트 eFuse 고압측 스위치
홈
전력 관리
고압측 스위치 및 컨트롤러
스마트 eFuse 고압측 스위치
신규

TPS4816-Q1

활성

I2t, 단락 보호 및 진단 기능이 포함되어 있는 오토모티브, 100V 저 IQ 고압측 드라이버

지금 주문
데이터 시트

TPS4816-Q1

활성
데이터 시트 지금 주문

제품 상세 정보

FET External Number of channels 1 Rating Automotive Operating voltage (max) (V) 100 Operating voltage (min) (V) 3.5 Control interface GPIO Features Current monitoring, Current sense/monitor, Fault Diagnostic, High-side RSNS, I2T, MOSFET Gate Driver, Over Voltage Protection, Overcurrent protection with adjustable delay, Overtemperature protection, Precharge FET driver, Reverse polarity protection, Second Gate Drive, Short circuit protection, Under voltage lock out Current sense accuracy +/-2% at 30-mV VSNS Operating temperature range (°C) -40 to 125
FET External Number of channels 1 Rating Automotive Operating voltage (max) (V) 100 Operating voltage (min) (V) 3.5 Control interface GPIO Features Current monitoring, Current sense/monitor, Fault Diagnostic, High-side RSNS, I2T, MOSFET Gate Driver, Over Voltage Protection, Overcurrent protection with adjustable delay, Overtemperature protection, Precharge FET driver, Reverse polarity protection, Second Gate Drive, Short circuit protection, Under voltage lock out Current sense accuracy +/-2% at 30-mV VSNS Operating temperature range (°C) -40 to 125
VQFN (RGE) 23 16 mm² 4 x 4

  • AEC-Q100 automotive qualified for grade 1 temperature
  • 3.5V to 95V input range (100V absolute maximum)
  • Reverse input and output protection down to –60V
  • Integrated 12V charge pump
  • Low 1µA shutdown current (EN/UVLO = Low)
  • Dual gate drive: GATE = 0.5A src/2A sink, G = 100µA src/0.39A sink
  • Integrated pre-charge switch driver (INP_G) to drive capacitive loads
  • Accurate I2t overcurrent protection (IOC) with adjustable circuit breaker timer (I2t)
  • Accurate (±5%) and fast (5µs) short-circuit protection
  • Accurate analog bi-directional current monitor output (IMON, I_DIR): ±2% at 30mV VSNS
  • NTC based overtemperature sensing (TMP) and monitoring output (ITMPO)
  • Fault indication (FLT) during short circuit fault, I2t, charge pump UVLO, OV, overtemperature
  • TPS48160-Q1 (I2t enabled), TPS48161-Q1 (I2t disabled)
  • Accurate (±2%) and adjustable undervoltage lockout (UVLO) and overvoltage protection (OV)

  • AEC-Q100 automotive qualified for grade 1 temperature
  • 3.5V to 95V input range (100V absolute maximum)
  • Reverse input and output protection down to –60V
  • Integrated 12V charge pump
  • Low 1µA shutdown current (EN/UVLO = Low)
  • Dual gate drive: GATE = 0.5A src/2A sink, G = 100µA src/0.39A sink
  • Integrated pre-charge switch driver (INP_G) to drive capacitive loads
  • Accurate I2t overcurrent protection (IOC) with adjustable circuit breaker timer (I2t)
  • Accurate (±5%) and fast (5µs) short-circuit protection
  • Accurate analog bi-directional current monitor output (IMON, I_DIR): ±2% at 30mV VSNS
  • NTC based overtemperature sensing (TMP) and monitoring output (ITMPO)
  • Fault indication (FLT) during short circuit fault, I2t, charge pump UVLO, OV, overtemperature
  • TPS48160-Q1 (I2t enabled), TPS48161-Q1 (I2t disabled)
  • Accurate (±2%) and adjustable undervoltage lockout (UVLO) and overvoltage protection (OV)

TPS4816-Q1 is a family of low IQ smart high side drivers with protection and diagnostics. With wide operating voltage range of 3.5V to 95V, (100V absolute-maximum rating) the device is suitable for 12V, 24V, and 48V automotive system designs.

The device has a strong 0.5A peak source and 2A peak sink GATE driver that enables power switching using parallel FETs in high current system designs. Use INP as the gate driver control input. MOSFET slew rate control (ON and OFF) is possible by placing external R-C components.

It also integrates a pre-charge driver (G) with control input (INP_G). This features enables designs that must drive large capacitive loads. In shutdown mode, the controller draws a total shutdown current of 1µA at 48V supply input.

The device has accurate bi-directional current sensing (±2%) output (IMON, I_DIR) with adjustable I2t based overcurrent and short circuit protection (±5%) using an external RSNS resistor and FLT indication. Auto-retry and latch-off fault behavior can be configured. The device also has NTC based temperature sensing (TMP) and monitoring output (ITMPO) output for overtemperature detection of external FETs.

TPS4816-Q1 is available in a 23-pin VQFN package.

TPS4816-Q1 is a family of low IQ smart high side drivers with protection and diagnostics. With wide operating voltage range of 3.5V to 95V, (100V absolute-maximum rating) the device is suitable for 12V, 24V, and 48V automotive system designs.

The device has a strong 0.5A peak source and 2A peak sink GATE driver that enables power switching using parallel FETs in high current system designs. Use INP as the gate driver control input. MOSFET slew rate control (ON and OFF) is possible by placing external R-C components.

It also integrates a pre-charge driver (G) with control input (INP_G). This features enables designs that must drive large capacitive loads. In shutdown mode, the controller draws a total shutdown current of 1µA at 48V supply input.

The device has accurate bi-directional current sensing (±2%) output (IMON, I_DIR) with adjustable I2t based overcurrent and short circuit protection (±5%) using an external RSNS resistor and FLT indication. Auto-retry and latch-off fault behavior can be configured. The device also has NTC based temperature sensing (TMP) and monitoring output (ITMPO) output for overtemperature detection of external FETs.

TPS4816-Q1 is available in a 23-pin VQFN package.
filter 기타 스마트 eFuse 고압측 스위치 찾기
다운로드 스크립트와 함께 비디오 보기 동영상

기술 자료

star =TI에서 선정한 이 제품의 인기 문서
검색된 결과가 없습니다. 검색어를 지우고 다시 시도하십시오.
1개 모두 보기
유형 직함 날짜
* Data sheet TPS4816-Q1 100V Low IQ Automotive High-Side Switch Controller With Bi-directional IMON, I2t, OV, and Diagnostics datasheet PDF | HTML 2025/05/27

설계 및 개발

추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.

계산 툴

TPS4816-Q1-CALC — TPS4816-Q1 design calculator

The design calculator allows customer to size the external peripheral components while designing with the TPS4816-Q1 controller.
지원되는 제품 및 하드웨어

지원되는 제품 및 하드웨어

제품
스마트 eFuse 고압측 스위치
TPS4816-Q1 — I2t, 단락 보호 및 진단 기능이 포함되어 있는 오토모티브, 100V 저 IQ 고압측 드라이버
다운로드
패키지 핀 CAD 기호, 풋프린트 및 3D 모델
VQFN (RGE) 23 Ultra Librarian
TI의 평가 항목에 대한 표준 약관이 적용됩니다.

주문 및 품질

포함된 정보:
  • RoHS
  • REACH
  • 디바이스 마킹
  • 납 마감/볼 재질
  • MSL 등급/피크 리플로우
  • MTBF/FIT 예측
  • 물질 성분
  • 인증 요약
  • 지속적인 신뢰성 모니터링
포함된 정보:
  • 팹 위치
  • 조립 위치

권장 제품에는 본 TI 제품과 관련된 매개 변수, 평가 모듈 또는 레퍼런스 디자인이 있을 수 있습니다.

지원 및 교육

TI 엔지니어의 기술 지원을 받을 수 있는 TI E2E™ 포럼

포럼 주제 모두 보기(영문)

콘텐츠는 TI 및 커뮤니티 기고자에 의해 "있는 그대로" 제공되며 TI의 사양으로 간주되지 않습니다. 사용 약관을 참조하십시오.

품질, 패키징, TI에서 주문하는 데 대한 질문이 있다면 TI 지원을 방문하세요. ​​​​​​​​​​​​​​

동영상