STDA066 November   2026 DRA821U , DRA821U-Q1 , TDA4AEN-Q1 , TDA4VEN-Q1 , TDA4VH-Q1 , TDA4VL-Q1 , TDA4VM , TDA4VM-Q1 , TDA4VP-Q1

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
    1. 1.1 GPIO in Automotive Applications
    2. 1.2 The J7 GPIO Virtualization Solution
  5. 2GPIO Hardware Architecture
    1. 2.1 GPIO Module Structure
    2. 2.2 GPIO Instances Across J7 Devices
  6. 3GPIO Interrupt Modes
    1. 3.1 Bank Interrupt Mode
    2. 3.2 Line (Per-Pin) Interrupt Mode
    3. 3.3 The BINTEN Register — A Critical Hardware Constraint
    4. 3.4 Interrupt Mode Comparison
  7. 4GPIO Virtualization Architecture
    1. 4.1 The Virtual GPIO Concept
    2. 4.2 The PADCONFIG VGPIO_SEL Field
  8. 5Interrupt Routing Architecture
    1. 5.1 The GPIO Interrupt Router
  9. 6Multi-Core GPIO Virtualization — Validated Scenario
    1. 6.1 Test Configuration
    2. 6.2 Observed Results
  10. 7Conclusion
  11. 8References

GPIO Module Structure

Each GPIO module instance on J7 devices follows a standard block-structured layout. The module is organized into banks of 16 GPIO signals each.

  • Pins per bank: 16
  • Banks per module: 9 (Bank 0 through Bank 8)
  • Maximum pins per instance: 144 (9 × 16), though actual usable pins depend on device pinout

Each GPIO pin within the module supports:

  • Direction control (input or output) per pin
  • Rising-edge trigger, falling-edge trigger, or both-edges trigger per pin
  • Set and clear output control (atomic, no read-modify-write needed)
  • Interrupt or DMA event generation in bank or per-pin (line) mode