SLAU367P October 2012 – April 2020
In oversampling baud-rate mode, calculation of the length of bit i Tbit,TX[i] is based on the baud-rate generator UCBRx, UCBRFx and UCBRSx settings:
Where:
≤
= Sum of ones from the corresponding row in Table 30-3
mUCBRSx[i] = Modulation of bit i of UCBRSx
This results in an end-of-bit time tbit,TX[i] equal to the sum of all previous and the current bit times:
To calculate bit error, this time is compared to the ideal bit time tbit,ideal,TX[i]:
tbit,ideal,TX[i] = (1/baud rate)(i + 1)
This results in an error normalized to one ideal bit time (1/baud rate):
ErrorTX[i] = (tbit,TX[i] – tbit,ideal,TX[i]) × baud rate × 100%