SLOSE88A December 2024 – March 2025 TAS6754-Q1
PRODUCTION DATA
Manual DC load diagnostics can be enabled in any state after all power supplies are within the recommended operating range and after the device has transitioned to SLEEP state for the first time. DC diagnostics can be enabled manually by setting the I2C control state register to LOAD DIAG state to run on any or all channels. If either the STBY pin or a GPIO pin function set the device to SLEEP or DEEP SLEEP state, manual DC Load diagnostics cannot be run. This doesn’t apply when the device is set to SLEEP or DEEP SLEEP state through I2C control, in which manual DC Load diagnostics are available.