SNAU308A November   2024  – May 2025

1.   1
2.   Description
3.   Get Started
4.   Features
5.   Applications
6.   6
7. 1Evaluation Module Overview
   1. 1.1 Introduction
   2. 1.2 Kit Contents
   3. 1.3 Specification
   4. 1.4 Device Information
8. 2Hardware
   1. 2.1 Setup
      1. 2.1.1 Evaluation Setup Requirement
      2. 2.1.2 Connection Diagram
   2. 2.2 Jumper Information
   3. 2.3 Power Requirements
   4. 2.4 Reference Clock
   5. 2.5 Output Connections
   6. 2.6 Test Points
9. 3Software
   1. 3.1 Software Description
   2. 3.2 Software Installation
   3. 3.3 USB2ANY Interface
10. 4Implementation Results
    1. 4.1 Evaluation Setup
    2. 4.2 Performance Data and Results
       1. 4.2.1 RF Output
       2. 4.2.2 VCO Calibration
          1. 4.2.2.1 No Assist Operation
          2. 4.2.2.2 Full Assist Operation
       3. 4.2.3 SYSREF
          1. 4.2.3.1 SYSREF Clock Generation
          2. 4.2.3.2 SYSREF Pulse Generation
          3. 4.2.3.3 SYSREF Repeater Mode
       4. 4.2.4 Phase Adjustment
       5. 4.2.5 Phase Synchronization
          1. 4.2.5.1 Category 1b and Category 2 SYNC
          2. 4.2.5.2 Category 3 SYNC
       6. 4.2.6 Pin Mode
11. 5Hardware Design Files
    1. 5.1 Schematics
    2. 5.2 PCB Layouts
    3. 5.3 Bill of Materials (BOM)
12. 6Additional Information
    1. 6.1 Debug Information
    2. 6.2 Trademarks
13. 7Revision History