LM5045

現行

具整合式 MOSFET 驅動器的全橋 PWM 控制器

產品詳細資料

Vin (max) (V) 14 Operating temperature range (°C) -40 to 125 Control mode Current Topology Full bridge, Half bridge, Push pull Rating Catalog Features Current limiting, High-voltage startup, Integrated gate drivers, Multi-topology, SR logic, Synchronization pin Duty cycle (max) (%) 50
Vin (max) (V) 14 Operating temperature range (°C) -40 to 125 Control mode Current Topology Full bridge, Half bridge, Push pull Rating Catalog Features Current limiting, High-voltage startup, Integrated gate drivers, Multi-topology, SR logic, Synchronization pin Duty cycle (max) (%) 50
HTSSOP (PWP) 28 62.08 mm² 9.7 x 6.4 WQFN (RSG) 28 25 mm² 5 x 5
  • Highest Integration Controller for Small Form
    Factor, High-Density Power Converters
  • High-Voltage Start-Up Regulator
  • Intelligent Sync Rectifier Start-Up Allows Linear
    Turnon Into Prebiased Loads
  • Synchronous Rectifiers Disabled in UVLO mode and
    Hiccup Mode
  • Two Independent, Programmable Synchronous Rectifier
    Dead-Time Adjustments
  • Four High-Current 2-A Bridge Gate Drivers
  • Wide-Bandwidth Optocoupler Interface
  • Configurable for Either Current Mode or Voltage
    Mode Control
  • Dual-Mode Overcurrent Protection
  • Resistor Programmed 2-MHz Oscillator
  • Programmable Line UVLO and OVP
  • Highest Integration Controller for Small Form
    Factor, High-Density Power Converters
  • High-Voltage Start-Up Regulator
  • Intelligent Sync Rectifier Start-Up Allows Linear
    Turnon Into Prebiased Loads
  • Synchronous Rectifiers Disabled in UVLO mode and
    Hiccup Mode
  • Two Independent, Programmable Synchronous Rectifier
    Dead-Time Adjustments
  • Four High-Current 2-A Bridge Gate Drivers
  • Wide-Bandwidth Optocoupler Interface
  • Configurable for Either Current Mode or Voltage
    Mode Control
  • Dual-Mode Overcurrent Protection
  • Resistor Programmed 2-MHz Oscillator
  • Programmable Line UVLO and OVP

The LM5045 PWM controller contains all of the features necessary to implement full-bridge topology power converters using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100 V. This highly integrated controller-driver provides dual 2-A high-side and low-side gate drivers for the four external bridge MOSFETs plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the leading and trailing edge dead-time between the main and synchronous rectifier control signals. Intelligent start-up of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2-MHz capable oscillator with synchronization capability and thermal shutdown.

The LM5045 PWM controller contains all of the features necessary to implement full-bridge topology power converters using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100 V. This highly integrated controller-driver provides dual 2-A high-side and low-side gate drivers for the four external bridge MOSFETs plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the leading and trailing edge dead-time between the main and synchronous rectifier control signals. Intelligent start-up of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2-MHz capable oscillator with synchronization capability and thermal shutdown.

下載 觀看有字幕稿的影片 影片

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件,然後再試一次。
檢視所有 5
類型 標題 日期
* Data sheet LM5045 Full-Bridge PWM Controller With Integrated MOSFET Drivers datasheet (Rev. H) PDF | HTML 2015年 1月 28日
Selection guide Power Management Guide 2018 (Rev. R) 2018年 6月 25日
User guide AN-2111 LM5045 Evaluation Board (Rev. C) 2013年 5月 6日
Application note AN-2213 LM5045 Based 240W Power Converter Using Full-Wave (Rev. A) 2013年 5月 6日
Application note Applying I2C-Compatible Temperature Sensors in Systems With Slow Clock Edges (Rev. A) 2013年 5月 6日

設計與開發

如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

LM5045EVAL — 適用於 LM5045 的評估板

The LM5045 evaluation board is designed to provide the design engineer with a fully functional power converter based on the full-bridge topology to evaluate the LM5045 PWM controller. The evaluation board is provided in an industry standard quarter brick footprint.
TI.com 無法提供
模擬型號

LM5045 PSPICE Model

SNVM006.ZIP (350 KB) - PSpice Model
計算工具

SLUC501 LM5045 Design Calculator

支援產品和硬體

支援產品和硬體

產品
AC/DC 和 DC/DC 控制器 (外部 FET)
LM5045 具整合式 MOSFET 驅動器的全橋 PWM 控制器
參考設計

PMP31092 — 小巧的 140-W 全橋參考設計

此電源供應器為 140-W 全橋式參考設計,適用因平面變壓器而需要高密度和低元件高度的應用。此設計以硬性切換全橋拓撲為基礎,於二次側使用 Schottky 二極體並由 LM5045 驅動。採用平面變壓器以將體積和高度降到最低。印刷電路板 (PCB) 有六層,元件安裝於上方及下方。裝置專為在環境溫度 (TA) < 40°C 的額定負載下持續運作而設計。在較高環境溫度下,建議使用 200 每分鐘直線英呎 (LFM) 的最小氣流。
Test report: PDF
封裝 針腳 CAD 符號、佔位空間與 3D 模型
HTSSOP (PWP) 28 Ultra Librarian
WQFN (RSG) 28 Ultra Librarian

訂購與品質

內含資訊:
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊:
  • 晶圓廠位置
  • 組裝地點

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

內容係由 TI 和社群貢獻者依「現狀」提供,且不構成 TI 規範。檢視使用條款

若有關於品質、封裝或訂購 TI 產品的問題,請參閱 TI 支援。​​​​​​​​​​​​​​

影片