SLUUCP8B June 2024 – October 2026 BQ41Z50
The BQ41Z50 device can shut down upon the assertion of the DISP pin when the configuration bits [IO_SHUT] = 1 and [LED_EN] = 0. This feature is disabled when the LED display is enabled. When the pin is asserted for IO Shutdown Delay, the gas gauge opens its DSG FET, then shuts down once PACK voltage < Charger Present Threshold. If the pin is deasserted or [IO_TIMEOUT] is set and IO Shutdown Timeout expires following activation before PACK voltage < Charger Present Threshold, then the shutdown is stopped and the DSG FET turns back on and returns to the state it was in before the pin was asserted. An active low signal is detected when [IO_POL] = 0. An active high signal is detected when [IO_POL] = 1. An internal pullup is enabled when [IO_PUL_DIS] = 0. The pullup is disabled when [IO_PUL_DIS] = 1. The pin is sampled every 250ms.
| Status | Condition | Action |
|---|---|---|
| Trip | DISP asserted AND the [IO_SHUT] bit is set. | Turn DSG FET off |
| Shutdown | Voltage at PACK pin < Charger Present Threshold | Send device into SHUTDOWN mode. |
| Exit | Voltage at PACK pin > VSTARTUP | OperationStatus()[IOSHUT] = 0 Return to NORMAL mode. |
The DISP pin for IO-based shutdown is configurable via the Settings: GPIO: IO Shutdown pin number in the Data Flash (default pin 7). To avoid unexpected behavior, ensure this pin number is unique and does not conflict with other GPIO functions (e.g. Pres, Emergency Shutdown, or BTP pins) also assigned in the Data Flash. Additionally, if the GPIO pin is configured as an output using the Settings:Flag Map: Set Up Configuration to display RAM register flags, ensure it does not conflict with its use as an input for IO Shutdown, as this may lead to overridden or inverted shutdown logic.