SimpleLink™ 32-bit Arm Cortex-M4 Wi-Fi® wireless MCU with 2 TLS/SSL and 256kB RAM
Product details
Parameters
Package | Pins | Size
Features
- CC3200 SimpleLink Wi-Fi—Consists of
Applications Microcontroller, Wi-Fi Network
Processor, and Power-Management Subsystems - Wi-Fi CERTIFIED™ Chip
- Applications Microcontroller Subsystem
- ARM® Cortex®-M4 Core at 80 MHz
- Embedded Memory
- RAM (Up to 256KB)
- External Serial Flash Bootloader, and
Peripheral Drivers in ROM
- 32-Channel Direct Memory Access (µDMA)
- Hardware Crypto Engine for Advanced Fast
Security, Including- AES, DES, and 3DES
- SHA2 and MD5
- CRC and Checksum
- 8-Bit Parallel Camera Interface
- 1 Multichannel Audio Serial Port (McASP)
Interface with Support for Two I2S Channels - 1 SD/MMC Interface
- 2 Universal Asynchronous Receivers and
Transmitters (UARTs) - 1 Serial Peripheral Interface (SPI)
- 1 Inter-Integrated Circuit (I2C)
- 4 General-Purpose Timers with 16-Bit Pulse-
Width Modulation (PWM) Mode - 1 Watchdog Timer
- 4-Channel 12-Bit Analog-to-Digital Converters
(ADCs) - Up to 27 Individually Programmable, Multiplexed
GPIO Pins
- Dedicated External SPI Interface for Serial Flash
- Wi-Fi Network Processor Subsystem
- Featuring Wi-Fi Internet-On-a-Chip™
- Dedicated ARM MCU
Completely Offloads Wi-Fi and Internet
Protocols from the Application Microcontroller - Wi-Fi and Internet Protocols in ROM
- 802.11 b/g/n Radio, Baseband, Medium Access
Control (MAC), Wi-Fi Driver, and Supplicant - TCP/IP Stack
- Industry-Standard BSD Socket Application
Programming Interfaces (APIs) - 8 Simultaneous TCP or UDP Sockets
- 2 Simultaneous TLS and SSL Sockets
- Industry-Standard BSD Socket Application
- Powerful Crypto Engine for Fast, Secure Wi-Fi
and Internet Connections with 256-Bit AES
Encryption for TLS and SSL Connections - Station, AP, and Wi-Fi Direct™ Modes
- WPA2 Personal and Enterprise Security
- SimpleLink Connection Manager for
Autonomous and Fast Wi-Fi Connections - SmartConfig™ Technology, AP Mode, and
WPS2 for Easy and Flexible Wi-Fi Provisioning - TX Power
- 18.0 dBm @ 1 DSSS
- 14.5 dBm @ 54 OFDM
- RX Sensitivity
- –95.7 dBm @ 1 DSSS
- –74.0 dBm @ 54 OFDM
- Application Throughput
- UDP: 16 Mbps
- TCP: 13 Mbps
- Power-Management Subsystem
- Integrated DC-DC Supports a Wide Range of
Supply Voltage:- VBAT Wide-Voltage Mode: 2.1 to 3.6 V
- VIO is Always Tied with VBAT
- Preregulated 1.85-V Mode
- Advanced Low-Power Modes
- Hibernate: 4 µA
- Low-Power Deep Sleep (LPDS): 250 µA
- RX Traffic (MCU Active): 59 mA @ 54 OFDM
- TX Traffic (MCU Active): 229 mA @ 54 OFDM,
Maximum Power - Idle Connected (MCU in LPDS):
825 µA @ DTIM = 1
- Integrated DC-DC Supports a Wide Range of
- Clock Source
- 40.0-MHz Crystal with Internal Oscillator
- 32.768-kHz Crystal or External RTC Clock
- Package and Operating Temperature
- 0.5-mm Pitch, 64-Pin, 9-mm × 9-mm QFN
- Ambient Temperature Range: –40°C to 85°C
Description
Start your design with the industry’s first Wi-Fi CERTIFIED single-chip microcontroller unit (MCU) with built-in Wi-Fi connectivity. Created for the Internet of Things (IoT), the SimpleLink CC3200 device is a wireless MCU that integrates a high-performance ARM Cortex-M4 MCU, allowing customers to develop an entire application with a single IC. With on-chip Wi-Fi, Internet, and robust security protocols, no prior Wi-Fi experience is required for faster development. The CC3200 device is a complete platform solution including software, sample applications, tools, user and programming guides, reference designs, and the TI E2E™ support community. The device is available in a QFN package that is easy to layout.
The applications MCU subsystem contains an industry-standard ARM Cortex-M4 core running at 80 MHz. The device includes a wide variety of peripherals, including a fast parallel camera interface, I2S, SD/MMC, UART, SPI, I2C, and four-channel ADC. The CC3200 family includes flexible embedded RAM for code and data and ROM with external serial flash bootloader and peripheral drivers.
The Wi-Fi network processor subsystem features a Wi-Fi Internet-on-a-Chip and contains an additional dedicated ARM MCU that completely offloads the applications MCU. This subsystem includes an 802.11 b/g/n radio, baseband, and MAC with a powerful crypto engine for fast, secure Internet connections with 256-bit encryption. The CC3200 device supports Station, Access Point, and Wi-Fi Direct modes. The device also supports WPA2 personal and enterprise security and WPS 2.0. The Wi-Fi Internet-on-a-chip includes embedded TCP/IP and TLS/SSL stacks, HTTP server, and multiple Internet protocols.
The power-management subsystem includes integrated DC-DC converters supporting a wide range of supply voltages. This subsystem enables low-power consumption modes, such as the hibernate with RTC mode requiring less than 4 µA of current.
Same functionality and pinout but is not an equivalent to the compared device:
Similar but not functionally equivalent to the compared device:
Technical documentation
Design & development
For additional terms or required resources, click any title below to view the detail page where available.Hardware development
Description
The SimpleLink™ Wi-Fi® CC3200 LaunchPad™ development kit (with QFN-packaged device) is an evaluation development platform for the CC3200 wireless microcontroller (MCU), the industry’s first single-chip programmable MCU with built-in Wi-Fi connectivity. The board features on-board emulation (...)
Features
- CC3200 Wi-Fi wireless microcontroller (MCU) in QFN package
- Industry’s first devices to be Wi-Fi CERTIFIED™ at the chip level by the Wi-Fi Alliance™
- USB interface to PC for CCS/IAR using FTDI USB drivers
- Flash update over the USB using SimpleLink Programmer
- 2 20-pin connectors enables compatibility with (...)
Description
The SimpleLink™ Wi-Fi® CC3200 Audio BoosterPack enables the evaluation and development with the digital audio peripheral [I2S] present on the SimpleLink™ Wi-Fi® CC3200 device. It contains a Class-D power amplifier to drive speakers and an ultra-low power audio codec, TLV320AIC3254, supporting (...)
Features
- 1 Microphone
- 1 audio 3.5 mono jack
- 2 audio 3.5 mm stereo jack (in and out)
- Onboard speaker connector using terminal blocks (stereo)
- Onboard audio codec (TLV320AIC3254)
- Onboard class-D audio power amplifier (TPA2012D2)
Description
The SimpleLink™ Wi-Fi® CC3200 SensorTag development kit is one of the quickest and easiest ways to connect sensors directly to the cloud!
The new Wi-Fi SensorTag kit is based on the low-power SimpleLink Wi-Fi CC3200 wireless MCU, the industry’s first Wi-Fi CERTIFIED™ single-chip (...)
Features
- Connect sensors directly to the cloud with WiFi
- Cloud connectivity lets you access and control your SensorTag from anywhere
- Get connected quickly, set up and connect in 3 minutes!
- Upgrade the SensorTag firmware over-the-air from the SensorTag smartphone app
Description
Features
- Remote data acquisition
- Cloud connectivity
- Big data collection for use-case analysis
- Power profile generation and comparison
- Usage of standard presentation and charting tools (e.g Plot.ly, excel)
Description
The Spectrum Digital XDS200 is the first model of the XDS200 family of debug probes (emulators) for TI processors. The XDS200 family features a balance of low cost with good performance between the super low cost XDS110 and the high performance XDS560v2, while supporting a wide variety of standards (...)
Features
The XDS200 is the mid-range family of JTAG debug probes (emulators) for TI processors. Designed to deliver good performance and the most common features that place it between the low cost XDS110 and the high performance XDS560v2, the XDS200 is the balanced solution to debug TI microcontrollers (...)
Description
The XDS560v2 System Trace is the first model of the XDS560v2 family of high-performance debug probes (emulators) for TI processors. The XDS560v2 is the highest performance of the XDS family of debug probes and supports both the traditional JTAG standard (IEEE1149.1) and cJTAG (IEEE1149.7).
The (...)
Features
XDS560v2 is the latest variant of the XDS560 family of high-performance debug probes (emulators) for TI processors. With the fastest speeds and most features of the entire XDS family, XDS560v2 is the most comprehensive solution to debug TI microcontrollers, processors and wireless connectivity (...)
Description
The XDS560v2 System Trace is the first model of the XDS560v2 family of high-performance debug probes (emulators) for TI processors. The XDS560v2 is the highest performance of the XDS family of debug probes and supports both the traditional JTAG standard (IEEE1149.1) and cJTAG (IEEE1149.7).
The (...)
Features
-
XDS560v2 is the latest variant of the XDS560 family of high-performance debug probes (emulators) for TI processors. With the fastest speeds and most features of the entire XDS family, XDS560v2 is the most comprehensive solution to debug TI microcontrollers, processors and wireless connectivity (...)
Description
Features
- 1.85/3.3V bidrectional conversion
- Compatible with TI Launchpads
- Wi-Fi Video Streaming
Software development
Features
Categories of applications are outlined below:
- Internet-on-a-chip sample applications
- Email from SimpleLink Wi-Fi solution
- Information center: get time and weather from the internet
- http server: host a web page on SimpleLink Wi-Fi solution
- XMPP: IM chat client
- Serial interface
- Wi-Fi sample applications
- Easy (...)
Download on Google play
The SimpleLink™ Wi-Fi® Starter Pro mobile App is a new mobile application for SimpleLink provisioning. It goes along with the embedded provisioning library and example that runs on the device side. The new provisioning release is TI (...)
Features
- Works seamlessly with SimpleLink Wi-Fi CC32xx LaunchPad and CC31xx BoosterPack
- Uses 4-wire UART for control and communication
- Transmit Wi-Fi packets in packetized and continuous modes
- Graphical User Interface (GUI) for configuration and display
- User-defined configuration of channel, power level (...)
Features
- Simple & easy-to-use code editor & compiler with built-in Serial Monitor/terminal
- Features a robust framework of intuitive functional APIs for controlling microcontroller peripherals (i.e. digitalRead, digitalWrite, Serial.print, etc)
- Support for various TI embedded devices (MSP430, TM4C, CC3200 (...)
CCS Uniflash is a standalone tool used to (...)
Design tools & simulation
Features
- Modules listed are based on TI wireless technology supporting Wi-Fi®, Bluetooth®, Zigbee®, Sub-1 GHz, Sigfox, 2.4 GHz, multi-band connectivity and more
- Modules integrate clocks, SPI flash and passive components
- Listings included for hardware customization, software integration and cloud services
- Listings (...)
- Step 1: Before requesting a review, it is important that to review the technical documentation and design & development resources available on the corresponding product page (see CC3XXX product page links below).
- Step 2: Download and (...)
Features
- The SIMPLELINK-CC3XXX-REPORTS link provides access to SimpleLink CC3xxx certification reports for:
- CC3xxx modules
- CC3xxx evaluation boards (note: reports for evaluation boards are for reference only)
- The SIMPLELINK-CC3XXX-REQUEST link provides
- A TI letter of authorization for FCC and ISED when requested (...)
Reference designs
CAD/CAE symbols
Package | Pins | Download |
---|---|---|
VQFN (RGC) | 64 | View options |
Ordering & quality
- RoHS
- REACH
- Device marking
- Lead finish/Ball material
- MSL rating/Peak reflow
- MTBF/FIT estimates
- Material content
- Qualification summary
- Ongoing reliability monitoring
Recommended products may have parameters, evaluation modules or reference designs related to this TI product.
Support & training
TI E2E™ forums with technical support from TI engineers
Content is provided "as is" by TI and community contributors and does not constitute TI specifications. See terms of use.
If you have questions about quality, packaging or ordering TI products, see TI support.